Skip to main content

W2E-Gateway-Pico (Preliminary)

Overview

W2E-Gateway-Pico is an evaluation board based on Raspberry Pi RP2040; it supports both wired and wireless connection by using WizFi360 and W5100S - with the ability to connect to the Cloud easily through wired or wireless and can be used for prototyping IoT solutions.

  • Raspberry Pi Pico Clone
  • Wi-Fi (WizFi360)
  • Ethernet (W5100S)

Features

  • RP2040 microcontroller with 2MByte Flash
    • Dual-core cortex M0+ at up to 133MHz
    • 264kByte multi-bank high performance SRAM
    • External Quad-SPI Flash with eXecute In Place (XIP)
  • Includes WizFi360-PA
    • WiFi 2.4G, 802.11 b/g/n
    • Support Station / SoftAP / SoftAP+Station operation modes
    • Support “Data pass-through” and “AT command data transfer” mode
    • Support serial AT command configuration
    • Industrial grade (operating temperature range: -40 ° C ~ 85 ° C)
    • CE, FCC certification`
  • Includes W5100S
    • Supports Hardwired Internet Protocols: TCP, UDP, WOL over UDP, ICMP, IGMPv1/v2, IPv4, ARP, PPPoE
    • Supports 4 Independent Hardware SOCKETs simultaneously
    • Internal 16 Kbytes Memory for TX/ RX Buffers
    • SPI Interface
  • Includes 16M-bit Flash Memory
  • Micro-USB B port for power and data (and for reprogramming the Flash)
  • 3-pin ARM Serial Wire Debug (SWD) port
  • 10 / 100 Ethernet PHY embedded
  • Supports Auto Negotiation
    • Full / Half Duplex
    • 10 / 100 Based
  • Built-in RJ45
  • Built-in LDO