Skip to main content

How to start WIZwiki-W7500ECO Board

When you get a WIZwiki-W7500ECO platform board first on your hand, the serial driver installation and hardware test are needed. Because WIZwiki-W7500ECO uses CMSIS-DAP firmware writing and does serial communicate through UART2 on W7500 (Target MCU).


To install the serial driver#

To install the serial driver from ARM mbed, please refer to the below link.

How to install WIZwiki-W7500ECO serial driver


Hardware self-test#

WIZwiki-W7500ECO has a built-in default firmware. You can do self-test with the default firmware as below.

*[[:products:wizwiki_w7500eco:start_getting_started:write_firmware&#examples_binary | Download WIZwiki-W7500ECO Examples Binary]]

** Test Sequence **

1. Connect Ethernet cable, USB cable to WIZwiki-W7500ECO. If you have a SD card, insert the SD card.

2. Run the Device Manager in Control panel and check which COM port is allocated to the USB port on WIZwiki-W7500ECO.

3. Press Reset SW, then LED1 and LED2 on WIZwiki-W7500 will be turned on. If LED1 and LED2 are turned off, then press the Reset SW again.

<Serial setting>
Baud rate : 115200
Data bits : 8
Parity : None
Stop bits : 1
Flow : None

4.

If you have a SD card,It will turn on LED1 and LED2.
The following message prints out to the serial port.

Messages in case of a SD card inserted

If you do not have a SD card,
It will turn on LED1 only.
The following message prints out to the serial port.

Message in case of a SD card not inserted

5. Run a command window and proceed with the ping test to WIZwiki-W7500ECO.

6. WIZwiki-W7500ECO operates as loopback server.

7. Make proceed with the ping test or loopback test with an IP of 192.168.077.009 on WIZwiki-W7500ECO.

Necessarily, IP of the PC must also be set to 192.168.077.XXX.

8. If you can do everything well, then your WIZwiki-W7500ECO doesn't have any problem.

\<WRAP centeralign>

Welcome to WIZwiki-W7500ECO#

\</WRAP>